Introduction of EMI Filter In Medical Devices
Rated
currents: 0.5 to 300A
Various
types of connections: pin, IEC inlet, wire, solder lug, thread, terminal block,
etc.
Custom
specific versions available on request
Excellent common and differential mode
attenuation effect, guarantees the accuracy and reliability of medical
equipment;
Very low leakage current, fully comply
with the safety requirement of medical devices.
Items with IEC inlet or pin connection available, compact
structure, easy to install, high cost performance;
Three-phase versions are suitable for high power medical devices, which
are safe and effective.
Ac Noise Filter,EMI Filter In Medical Devices,EMI Filter For Medical Appliance,Medical Device Filters Jinan Filtemc Electronic Equipment Co., Ltd. , https://www.chinaemifilter.com
Recently, the Ministry of Economic Affairs of Taiwan issued an announcement setting out the “ballast energy efficiency benchmark for built-in light-emitting diode (LED) bulbsâ€, which will take effect on July 1, 2014.
The announcement pointed out that the ballast built-in LED bulbs (hereinafter referred to as LED bulbs) that are applicable to this benchmark should meet the standard CNS 15630 specifications and be declared by the Ministry of Economic Affairs and Standards Inspection Bureau as the scope of the inspection products. However, if the rated color rendering index (CRI) is above 95, the benchmark is not applicable.
According to the announcement, the luminous efficiency of LED bulbs should be above the value of the attached table. The measured input power of the LED bulb is calculated to the first digit after the decimal point, and the second digit after the decimal point is rounded off; the measured luminous flux is calculated to the whole digit, and the first digit after the decimal point is rounded off; the luminous efficiency is calculated to the first digit after the decimal point. The second digit after the decimal point is rounded off. 