[Installation and operation] Electronic Components Resistor
Resistor (Resistor) commonly known as resistance directly in our daily life.It is a current limiting element. When the resistance is connected to the circuit, the resistance value of the resistor is fixed, usually two pins.Fixed resistors are those whose resistances cannot be changed.Resistance variable is called potentiometer or variable resistor.The ideal resistor is linear, that is, the instantaneous current through the resistor is proportional to the applied instantaneous voltage.Variable resistor for partial pressure.On the exposed resistor body, one or two movable metal contacts are pressed tightly.The contact position determines the resistance between any end of the resistance body and the contact.
Electronic Components Resistor,Metal Film Resistor,Metal Oxide Film Resistor YANGZHOU POSITIONING TECH CO., LTD , https://www.yzpstcc.com
Start: Switch the auto/manual switch in the car top and the car to the automatic position.
Press and hold the down button while cutting the EQDO switch to ON, then release the button.
Operation: Press the button and the car will go up.
Press the down button and the car slows down.
End: Cut the EQDO switch to OFF.
[call record]
Start: Press the up button while cutting the EQDO switch to ON and then release.
Implementation: Press the button and the upper layer (press and hold for more than 2 seconds, top layer) is reserved.
Press the button and the lower layer (press and hold for more than 2 seconds, the bottom layer) is reserved.
Press and hold the middle button and the above reserved floor is recorded.
Keep the middle button pressed and the door will be closed.
End: Cut the EQDO switch to OFF.
[The floor selector is staggered]
Start: Press and hold the up button while cutting the EQDO switch to ON, then release the button
Implementation: Press the button and the upper layer (press and hold for more than 2 seconds, top layer) is reserved.
Press the button and the lower layer (press and hold for more than 2 seconds, the bottom layer) is reserved.
Press and hold the middle button, the selector on the above reserved floor is staggered.
End: Cut the EQDO switch to OFF
During the execution of "Call Record" and "Spread of Floor Selector", the recorded floor of the call floor and the floor that the selector is staggered will be displayed in binary numbers on bits 0~bit7 of the LED. (At the beginning of the operation, it shows the floor where the car was at the time)
Normally indicates the display of the LED when [SEL=0 data=0] 